Jump to content

How to delite this white marks


bp781

Recommended Posts

Posted · How to delite this white marks

I'll guess and say you have your Zseam location set to "Random".  Those blobs are something else though.

My next guess is that the printer/processor isn't keeping up with the gcode flow and those are stutters.  The nozzle has to stop for a split second while it waits for the next command and those stops will leave a little blob.

In the Cura Mesh Fixes section check your Maximum Resolution.  It should be around 0.4 or 0.5.  Smaller values allow really short line segments to be generated in the gcode so it takes a lot of lines of gcode to move the nozzle 1mm around a curve.

You could also try the ArcWelder plugin.  It converts the little line segments into curves and makes them G2 and G3 commands that the printer calculates as arcs and circles (kind of - they will still be line segments but subject to the Minimum Chord Length setting in your firmware.)  Not all firmware supports G2/G3.

  • Link to post
    Share on other sites

    • 2 weeks later...
    Posted · How to delite this white marks

    Hey @bp781,

     

    Thanks for your report 👍
    Those are some biiiig blobs on your zseam. 
    I think it's probably related to those settings, or to retraction settings.

     

    Do you have a project file for us? It contains the printer and settings we need for troubleshooting. 
    To save a project file go to File -> Save project.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
    ×
    ×
    • Create New...