Puts Infill, where it dosnt belong.

[ToB 0]

I have created a cooling pipe for my printer. There should be four empty spaces for the air, but Cura puts walls there and fills the space with infill. Does anyone have a solution for this?

Edited December 13, 2022 by ToB

[GregValiant 1,287]

It could be a model error but the easy check is to make sure you have Mesh Fixes "Remove all Holes" turned off and in Experimental make sure "Make Overhangs Printable" is turned off.  

[ToB 0]

No, the problem is also present in other models

[GregValiant 1,287]

If those settings are turned off then use the "File | Save Project" command and post the 3mf file here.  Someone will take a look.

Looking into the rectangular holes in your 2nd and 3rd images it looks like "Make Overhangs Printable" might be on.

[MariMakes 199]

Hey @ToB,

 

Welcome to the Ultimaker Community 🎉
I tend to agree with @GregValiant, I believe it's one of those settings that are affecting your printjob. 

 

Do you have a project file for us? It contains the printer and settings we need for troubleshooting. 
To save a project file go to File -> Save project.

[ToB 0]

I had the "Make Overhang Printable" setting on and overlooked it🤦‍♂️. Thanks for the help 🙂