Print and support does not line up.

[dfaulkner85 0]

When I perform a calibration my X and Y offset is perfect at 0 and 0. 

When I go to print my primary core prints perfect however my support core is shifted to one side about 7/8".  Any thoughts on what is going on?

[gr5 2,072]

 

Is it possible you are slicing for the S3 but printing on the S5 printer?

 

I don't know if the nominal offset between the nozzles is controlled by the printer itself or by cura.  I'm thinking maybe it's cura and the problem is with your machine settings somehow?

 

It looks like the value is here - 22mm check this for your machine settings (must go into PREPARE mode in cura, then click your printer dropdown and "manage printers"

 

[gr5 2,072]

7/8 inch is 22.2mm

[dfaulkner85 0]

Thank you ! It was the 22mm offset.  When I updated the firmware it reset to 0.0 for some reason.