PaulKuiper 11
It needs to be 60C. Before this it first pulls a thin neck at printing temperature, before it cools down to 60C to cleanly break this thin neck. This forms a proper filament tip that can move up and down the material handling system.
It needs to be 60C. Before this it first pulls a thin neck at printing temperature, before it cools down to 60C to cleanly break this thin neck. This forms a proper filament tip that can move up and down the material handling system.
Ah! So there are two retractions. One at a higher temp. One at 60C. It sounds like LXXIII has an issue with the filament stuck in the print core somewhere. I'd get a new printcore.
Recommended Posts
LXXXIII 0
From what I found in the Generic PLA material profile its 60°C
Link to post
Share on other sites