cura 5.2.1 support issue

[Bruce19 2]

imagine a pie plate flipped over and need of supports underneath.  I used the custom length on where I click one point then click another and the support runs from point to point.  Except with the "pie plate" I'm trying to support to print, the supports show up on top of the print. It's like it doesn't know how high to be.   I've used this support many times and never had this issue before.  

 

Cura 5.2.1

[GregValiant 1,305]

Well that sure looks like the support interface is poking through the model.

I don't recall a support structure like that in Cura.  Did you install a plugin from the MarketPlace?

[Bruce19 2]

yes It has been for quite a while. I've used it many times before with success     Right now I'm trying about 50 square supports as they were the ONLY support style NOT to go thru the print