Ultimaker 3 display backlight not working

[NicolaMondello 0]

Hello, suddenly the display of my Ultimaker 3 (firmware version 5.3.0) is without backlight. Any ideas on what could I check to repair it?

[Dustin 144]

Looks like your display has gone bad.

You will need to replace the OLED display module.
Any UltiMaker reseller should be able to offer the replacement.

[Enigma_M4 120]

Hi,

for your interest, the part number of the display is 1252.

UM3_Parts_Manual.pdf

Regards

[NicolaMondello 0]

Thanks for you answers! There are somewhere any installation instructions? I found a broken link into another similar post in the forum.

[gr5 2,194]

Here you go.  If you don't know how to take out the knob it's very tricky.  That's the only tricky part (taking out the knob).  This video shows the whole procedure though: 

 

[NicolaMondello 0]

Wow! thank you very much! I love u!!! 🙂