Looks like your retraction settings could be better... I used 1.5mm min travel, no combing, 0 min extrusion, and set travel moves to 250 - that helps prevent oozing that leads to the coral-effect branches growing away from the supports.
I also found that a 3Doodler hand-held extruder is useful for repairing broken supports if needed.
I'm hoping that Cura will get smarter about how it moves the head in future so that it avoids hitting supports as the head moves around.
Recommended Posts
gr5 2,224
I know the feeling!
I always do thicker supports than this. Maybe twice as thick. For this very reason. The match sticks and glue are brilliant.![:)](//content.invisioncic.com/ultimake/emoticons/5a33abdf6d109_1f60acopy.png)
Link to post
Share on other sites