Jump to content

strings and spots on the print


nickwu

Recommended Posts

Posted · strings and spots on the print

I printed two models that have been placed one after another at the same time, here is the result:

marvin 2

marvin 1

marvin 3

Some strings and spots came out between them, It seemed like the nozzle was oozing while moving between prints, any advice on how to improve that ?

here is my settings:

marvinPrintSettings 1

marvinPrintSettings 2

marvinPrintSettings 3

The build plate temperature is 60, nozzle temperature is 210 ,

Any advice would be greatly appreciated.

Sorry for my poor english :-/

 

  • Link to post
    Share on other sites

    Posted · strings and spots on the print

    Hello

    I believe that this problem can not be avoided to a hundred percent, but:

    You could be the "Travel speed" increase slightly, eg to 175mm / s

    Also you could "retraction lengt" and "retraction speed", slightly increase. The latter also goes directly to the machine under the "TUNE".

    Check also the Bowden whether this is properly seated firmly in the couplings and does not bounce during the printing process.

    Make a mark ring with a fine permanent marker on the Bowden tube, immediately after the coupling neck.

    Is keeping the coupling Bowden not reasonable, then it is necessary to Bowden to cut a few millimeters, so that the claws the coupling can engage in fresh material again.

    Markus

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
        • 3 replies
      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
    ×
    ×
    • Create New...