-
Our picks
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 3 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
UltiMaker Cura 5.7 stable released
ArunC posted a topic in UltiMaker Cura,
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
-
-
- 26 replies
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
gr5 2,192
For better overhangs the most important thing is 100% fan. So if the overhang is below 5mm from the bed you need to adjust the cura settings. Not as critical - it can help quite a bit to print slow. 20-35mm/sec. Also having a 2-pass-shell helps (make shell thickness 0.8). Also if layer thickness is too thin or too thick this might affect things - not completely sure about this detail - but anyway .08 is a reasonable choice for layer height.
So try .8mm shell and print at 20mm/sec just for an experiment to see if any better.
Other hints about other printing issues (not overhang) are here:
http://umforum.ultimaker.com/index.php?/topic/1872-some-calibration-photographs/
Link to post
Share on other sites