Try to reduce the infill percentage to 24% or less. That will make Cura put a full grid on each layer, instead of doing alternating layers in a alternating directions. Usually that gives a far more cohesive infill, as you are always printing on top of solid plastic.
Thanks, good to know! However, I am looking for more of a permanent solution to my issue because I would like to make parts with infill >24% at times.
Anyone have any suggestions?
Recommended Posts
illuminarti 18
Try to reduce the infill percentage to 24% or less. That will make Cura put a full grid on each layer, instead of doing alternating layers in a alternating directions. Usually that gives a far more cohesive infill, as you are always printing on top of solid plastic.
Link to post
Share on other sites