If you are Intressted in this Topic you might want to follow this Thred: http://umforum.ultimaker.com/index.php?/topic/7136-exploring-marlin-bed-auto-level/
Fabian
-
Our picks
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 3 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
UltiMaker Cura 5.7 stable released
ArunC posted a topic in UltiMaker Cura,
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
-
-
- 26 replies
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
mnis 11
Tried? No. In thinking a few times? YES.
Since Cura 14:07 including firmware, there was no longer any need for me so far. I print almost daily. Everything liable super on the glass, the contact surfaces look very good. Therefore, I believe that automatic bed-adjustment is a good thing, but really is little need for it, I think.
:idea: When I see later need for it, then I opt for the solutions with Hall sensors.
For what are the three screws under the bed? Damn... :wacko: :rolleyes: :lol:
Markus
Link to post
Share on other sites