Cura update with firmware update setup problem

[treth 0]

Was prompted to update Cura to 15.02.1 which I did and then to update the firmware which I also did. Then UM2 starts as 'new' so did setup, but when it came to the fine settings with a piece of paper under the nozzle for the front left and right positions the rotating button has no affect so cannot fine set!

There was not a rear left and right fine height setting either (think there was on last version installed).

Should I re-install firmware, if so how? or is it a bug?

 

[IRobertI 521]

You adjust the physical screws in the front right and left so the button should not have any effect. And there should not be a setting for the back left and right so it's doing what it's supposed to do.

 

[treth 0]

Excellent, thanks!

I should have dug out the excellent install manual, but didn't realise I would need it again.....