Jump to content
Ultimaker Community of 3D Printing Experts

How to hook up endstops?


treep78
 Share

Recommended Posts

Posted · How to hook up endstops?

I have a 1.5.7 electronics kit that came with a set of endstops that I can't figure out how to hook up. They have 4 wires instead of the usual two I usually see with ultimakers, +, -, empty, and signal. I'm not sure which ones too hook up to the electronics board. I know that there are two prongs for each endstop, but it don't know what each of the prongs are. Can anyone help me?

 

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 8 replies
    ×
    ×
    • Create New...