Few problems

[liborjanicek 0]

So a week ago we got the Ultimaker 2. Printed a few things and no problem. Now go to print stuff and the PLA sticks to the nozzle and not the plate. Also our printer doesn't sit level. None of the legs are damage. Bad build, I guess.

I've re-leveled the build plate and no luck.

Please help.

THX

 

[Labern 774]

Hi Welcome to the forum.

Clean the glass with alcohol to make sure there are no greasy fingerprints on it and try again.

Are you using ultimaker Pla?

Are you using the glue Stick?

What temperatures are you printing With?

[deepshots 2]

Sounds like your bed might be too far from your nozzle. Also externally dirty nozzle seems to make it easier for the plastic "curl" around the nozzle.

 

[yellowshark 153]

Also curling around the nozzle can result from a blockage in the nozzle, needing an atomic pull to clear. If you manually extrude filament, does it flow out from the nozzle absolutely perpendicularly? If yes then probably not your problem but if no then probably is your problem.