Cura under Linux

[dbvanhorn 0]

I have a Robo3D which works fine with my windows machine.

I am intending to move it to my Zotac linux box, (Fedora) which has Cura installed.

Unfortunately....

I have no evidence that Cura can communicate to the printer.

Cura knows if the printer isnt connected to the linux box. When I try to run the bed leveling wizard, Cura lets me know immediately that the printer isn't connected.

So I connect the printer, and then Cura searches forever (12 hours plus) and never connects to the printer.

What can I do

 

[gr5 2,189]

Do you need the bed leveling wizard? Don't you have some other way to level your printer? I would skip the Cura leveling wizard which I've never used and probably only works on ultimaker machines.

 

[nallath 1,123]

Its pyserial. Most printers communicate on the 25000 baud rate, which it doesn't support fully. There are patches floating arround that should fix this.