The keyboard issue should be fixed for 15.09.82.
We haven't looked into the different infill density, as the engineer that works on the engine is on a holiday now.
The keyboard issue should be fixed for 15.09.82.
We haven't looked into the different infill density, as the engineer that works on the engine is on a holiday now.
OK,
thanks for this information!
I cannot reproduce any bug in the infill percentage. Are you sure you haven't set the infill pattern to Grid instead of Lines?
With an infill percentage of 50% and the Lines pattern, the lines are as far apart as they are wide. For the Grid pattern they are 3 times as far apart as they are wide.
Perhaps this bug was due to the setting update bug which has been solved in the meantime.
Did you use the supplied STL file? It had a VERY small cylindrical area that was getting no infill even though there was room for it. It could be that this bug was fixed recently.
@bagell-orb - on aug 27 you posted that this bug was fixed. I think you can ignore this thread.
Hi,
where I can download the latest Cura built to verify that this issue is solved?
It's kind of a secret but if you search the forums you can probably figure it out. I'll pm you the location.
It's not secret: http://software.ultimaker.com/Cura_closed_beta/15.10/ (don't let the URL fool you, we're just lazy )
Hi,
thanks for the link, I downloaded the latest version now and tried again.
The problem is solved now.
And bagel-orb was right. For some reason the infill pattern was set to grid instead of lines. I don't know why since I never had this option visible in my Cura versions. Anyway I made this option visible now and detected it was set to grid.
Then I switched it back to lines and then the infill was same as in legacy Cura again, see here:
Just for fun I set it also to Concentric, but there is no infill at all, as you can see here:
Is this also a bug or not?
I don't want to push, but can anybody tell me if 'no infill' on Concentric pattern is a bug or not?
Thanks ;-)
It's a bug / not correctly impemented yet.
Hi nallath,
OK thanks.
I assume someone from ultimaker development team will take care?
Yep
Recommended Posts
3dnerd 6
Hi nallath,
what does this mean now?
- Will the keyboard issue be solved in one of the next releases?
- What about the different infill density (at same setting of 50%) of 15.09.81 compared to 15.02.1?
Edited by GuestLink to post
Share on other sites