I missed that blog post That's a good read....bookmarked!
In your settings you can choose to receive notifications when we publish a new blog post. You never have to miss anything again
- 1
I missed that blog post That's a good read....bookmarked!
In your settings you can choose to receive notifications when we publish a new blog post. You never have to miss anything again
CAN'T FIND IT :(There is not 1 temperature for filament, it depends on print layer and speed as well.
I would recommend to read this blog, we dedicated a part to print profiles.
Bed temps is 60ºC for PLA, 100ºC for ABS and CPE.
For PLA you usually don't need glue unless it is a pretty big print.
You could use a regular glue stick.
For ABS we do recommend to use a glue stick.
There is not 1 temperature for filament, it depends on print layer and speed as well.
I would recommend to read this blog, we dedicated a part to print profiles.
Bed temps is 60ºC for PLA, 100ºC for ABS and CPE.
For PLA you usually don't need glue unless it is a pretty big print.
You could use a regular glue stick.
For ABS we do recommend to use a glue stick.
CAN'T FIND IT :(
It is at the bottom of the blog.
And watch your capslock.
I missed that blog post That's a good read....bookmarked!
In your settings you can choose to receive notifications when we publish a new blog post. You never have to miss anything again
great tip thnx! when will the next part "printing" be published?
very interesting read was part 1 btw, thanks a lot for that!
I missed that blog post That's a good read....bookmarked!
In your settings you can choose to receive notifications when we publish a new blog post. You never have to miss anything again
great tip thnx! when will the next part "printing" be published?
very interesting read was part 1 btw, thanks a lot for that!
can you replay a link ? i can't find it
Recommended Posts
LePaul 331
I missed that blog post That's a good read....bookmarked!
Link to post
Share on other sites