Hi,
I'm also seeing this. I upgraded to 14.04.5 and I think I saw the issue then too, but I am not sure becasue I downgraded again on the advice of UM GB support due to a stepper motor issue.
I have seen this issue 3 times now in the last few days. I thought is was due to an overheating main board due to the steppers issue
https://ultimaker.com/en/community/21084-possible-motherboard-breakdown
Did Upgrading to 14.04.5 fix this for you?
Thanks,
Greg
Edited by Guest
Recommended Posts
Justaphf 0
I am having a similar issue with my UM2+ running with the firmware that came with Cura 15.04.4 (will be updating to 15.04.5 once the print finishes). Did you ever figure out a fix for this issue?
Backstory:
I am running a 28-hour print (scaled up version of the included tetra-wire example model), the screen seems to have locked up around 13 hours left with a line through the top line of text (and part of the second line) like a strike-through. There is no response to the control wheel, either rotating or pressing. The print itself however is still chugging along, I just can't tweek any of the print settings on-the-fly now with the UI unresponsive.
Link to post
Share on other sites