Yes right, I was able to figure it out checking at the layers view in Cura. By playing with parameters I was able to see the retraction (blue lines going up) on the concerned layers. Now I'll have to try it out but it will take time as I have to redo the 3D model as I have a problem of scale with the original/real one. I'll keep you inform.
Thanks again...
Recommended Posts
Labern 775
Is it actually retracting between each one? if not then you will need to reduce the minimum travel and the minimum extrusion before retracting.
As the rivets are rounded and small adjust the retraction minimum extrusion and travel amounts as small as possible. You can look in layer view to check to make sure its retracting between each one. If you make the amounts to small it may have excessive amount of retracting, so just lower them enough to make it so it retracts.
Link to post
Share on other sites