Did you check any of the other (many different) causes that can make the printer underextrude?
http://support.3dverkstan.se/article/23-a-visual-ultimaker-troubleshooting-guide#underextrusion
Also mandatory reading:
https://ultimaker.com/en/community/view/17040-um2-under-extrusion-problem#reply-115389
Btw @Sandervg the troubleshooting sticker was removed?
Edited by Guest
Recommended Posts
qmaker 29
Has anyone experimented with ways to potentially warm and straighten the filament before it gets close to the feeder? I know that it wouldn't be good to get the filament to warm before, but maybe enough to relax it a bit so that when you get to the feeder the memory of the spool coil isn't as intense.
Link to post
Share on other sites