If the 4 screws are tight... I had this on a umo+ because the LMU linear bearing was damaged, it did that 'clacky-di-clak'. I just bough other (only one was damaged) and send the other to the trash.
If you set new linear bearings, check the post from @DidierKlein about the X of the inner positioning, it's something I never seen documented anywhere.
https://ultimaker.com/en/troubleshooting/6375-top-layers-not-touching-um2?page=18#reply-121072
Btw Atomic method creator!! woohooo!!!
Recommended Posts
DidierKlein 729
Oh god it's the creator of the atomic method![:D](//content.invisioncic.com/ultimake/emoticons/5a33abe7dfbbe_1f600copy.png)
![;)](//content.invisioncic.com/ultimake/emoticons/5a33abe00be82_1f609copy.png)
Have you tried screwing the four long screws a bit more? I've never seen something like this before
Link to post
Share on other sites