Ultimaker Original is printing bigger on Z axis

[dezels 1]

I have some printing problems after upgrading.

Last week I bought an “Ulticontroller” and “Heatedbed” upgrade kit for my Ultimaker Original.

now I am printing with cura 15.04.6 because Cura 2.1.2 is not working very well with my Ultimaker.

After upgrading my Ultimaker Z axis scale is bigger.

15 mm box

I  checked  the jumpers on the Z stepper driver area. The first 2 jumpers installed and the 3rd jumper is not used.

My print is better scaled with all jumpers on.  

(ON-ON-OFF = scale +/- 300% Z)

(ON-ON-ON = scale +/- 200% Z)

Is somebody who can help me?

Thank you!!

[IRobertI 520]

Have you updated your firmware to match your upgrade and performed a factory reset?

[dezels 1]

Yes, in Cura I added a new machine, upgrade firmware and checked/reset all settings .

[neotko 1,417]

Go to Control -> Motion and change the z steps to 400. A factory reset removes the adjustments you could do or had on the machine and re-reads the info of the firmware.

[dezels 1]

Go to Control -> Motion and change the z steps to 400. A factory reset removes the adjustments you could do or had on the machine and re-reads the info of the firmware.

 

Control setting:

Accel: 4000

Vxy-jerk: 20

Vz-jerk: +000.40

Ve-jerk: 5

Vmax x: 500

Vmax y: 500

Vmax z: 5

Vmax e: 25

Amax x: 9000

Amax y: 9000

Amax z: 100

Amax e: 10000

A-retract: 3000

Xsteps/mm: +078.74

Ysteps/mm: +078.74

Zsteps/mm: +0400.1

Esteps/mm: +0836.0

Photo :

(What is a factory reset?) I did : calibration, bed levelling, fine-tuning.

Maybe you can see some mistakes or errors in my settings (ulticontroller)

[neotko 1,417]

Lol sorry. 200 steps on Z change that 400.1 to 200

Sorry for the mistake I'm at 5 thinks at the same time.

Edited August 2, 2016 by Guest

[dezels 1]

Lol sorry. 200 steps on Z change that 400.1 to 200

Sorry for the mistake I'm at 5 thinks at the same time.

 

Thank you!! It is a square! (not a rectangle anymore)

Is it possible to set this settings? Now I am spinning 200 every time.

[neotko 1,417]

You have a 'save settings' on Control -> Store memory

Also there you have an option called 'restore failsafe' that I think it does what @IRobertI suggested. I never used it so I'm not sure if does that

[dezels 1]

You have a 'save settings' on Control -> Store memory

Also there you have an option called 'restore failsafe' that I think it does what @IRobertI suggested. I never used it so I'm not sure if does that

 

Thank you !!! You made my day!!

[dezels 1]

answer :

"set settings" :

-Control -> Motion -> Zsteps/mm: +0200.0

"save settings":

-Control -> Store memory

Thank you Neotko!!!!