Power Cord loose fit

[DudeUser 0]

Hey,

i have a problem with my Ultimake 2+ the power cord has a rlly loose fit. One move and the power cord

falls down. I tried to push out the little nipples but it doesent help.

[Labern 775]

The power cord is really tight going in to the printer. You have to push it really hard till it clicks.

[DudeUser 0]

Does not help.

No click, still loose fit. Pretty annoying when changing filament.

[neotko 1,417]

Can you post some photos? Maybe there's something wrong with it. Also another of the connector on the printer.

Edited August 10, 2016 by Guest

[gr5 2,224]

This is a common problem. You aren't plugging it in all the way because the circuit board isn't centered in the hole. Loosen the 4 screws holding the circuit board - just loosen them a little - then you can plug the connector all the way on (it latches permanently and won't come off unless you slide the latch on the power cord). Then re-tighten the 4 screws that hold the circuit board in place.

[DudeUser 0]

Thank you gr 5, worked perfectly.