Changing Bed Temperature During Print 2+

[ianeagland 0]

Hi

I understand the Ultimaker 2+ has the bed temperature set on the machine. Does this mean you can no longer change bed temperature during a print? I have just replaced my Original with a 2+. I have a stack of ABS that I want to use up. After many months of experimenting I found that I needed to start with a bed temperature of 110 to get a good stick onto Kapton but could reduce to 85 after the first few layers.

Regards

Ian

[ultiarjan 1,223]

Yes for sure you can, but you need to inconveniently go through the menu's.

Things are soooo much easier if you just use the @tinkergnome firmware.

Your main settings always show directly in the display, and you can directly adjust from there.

https://ultimaker.com/en/community/33324-changing-bed-temperature-during-print-2

you can simply install the firmware using old (15.xx) cura

[ianeagland 0]

Many thanks

I realised you can change bed temperature with the manual control. What I should have asked is can I change the bed temperature within the gcode as I did on the Original?

Regards

Ian

[ultiarjan 1,223]

Yeah sure, you can just enter a code manually on the layer-height you want or use the tweak at Z plugin in cura.

[ianeagland 0]

Hi

Thanks. Just found tweak at Z in Cura 1.3

Edited November 14, 2016 by Guest

[gr5 2,189]

Yes, exact same gcode works as on UMO for controlling bed temp.