If you install the Tinkergnome firmware, you can change the bed temperature up to 120C, but the UM2 heated bed is really not powerful enough to reach it easily. It differs a bit between different units, but one of my UM2+ printers stabilizes pretty much at 108C when using the printer with a plexiglass door, and just a few degrees over 100C without the door.
If you cover the top it can probably reach higher temperatures.
@ultiarjan: i believe that you mean 95 and not 195 degrees on the bed
Recommended Posts
ultiarjan 1,223
Think the answer is yes, you can go higher than 100c, but I never heard anybody doing 120c.
But NO IDEA IF IT'S SAFE, nor any idea what it'll do to the life expectancy of the bed.
I never use higher than 95c (ABS) as even reaching 100c takes ages, even enclosed.
To change the max setting, use the tinker firmware;
https://ultimaker.com/en/community/20279-max-bed-temperature-limit-changed-lowered-after-extrusion-kit-upgrade-firmware-was-installed-on-um2
edit: changed 195c to 95c ....
Edited by GuestLink to post
Share on other sites