tinkergnome 927
Yup a brim disadvantage. To manage this I would suggest
1. Put a filet around the bottom surface
2. Buy a good quality modelling knife, useful if you have a compete wall you need to cut away; and a good set of jewellers files - probable cost 30-50 eu
3. Learn how to use a file - it will be on the internet somewhere or ask a jeweller
In addition: there are also special deburring tools (not very expensive).
No recommendation, only two examples to illustrate how it looks like:
http://www.ebay.com/itm/5-PIECE-DEBURRING-TOOL-SET-E-2001-0222-/232218419743
Recommended Posts
ultiarjan 1,223
Just don't use a brim. For many materials/prints you can do without it.
Link to post
Share on other sites
yellowshark 153
Yup a brim disadvantage. To manage this I would suggest
1. Put a filet around the bottom surface
2. Buy a good quality modelling knife, useful if you have a compete wall you need to cut away; and a good set of jewellers files - probable cost 30-50 eu
3. Learn how to use a file - it will be on the internet somewhere or ask a jeweller
Link to post
Share on other sites