Bug in Cura 2.6.2 on skirt lines

[yoda1490 0]

Hi,

I just discovered a small bug in Cura 2.6.2, the skirt lines are printed IN my model:

The model printed can be found here:

https://www.thingiverse.com/thing:2513624

Here are the settings used for skirt:

Yes I can change the distance, but I would like report it to the developers, i'm not sure to be at the right place.

Thank you

[gr5 2,230]

They will probably ignore this unless you test in 2.7 which is the latest released version.

[burtoogle 516]

Hi, I just tried slicing this with the current development code and it's fine. However, if I click on the object and slightly raise it above the build plate by setting Z to 0.2 then I see exactly the same result as you show above. Perhaps, your object isn't actually resting on the build plate?

[yoda1490 0]

oups ... yes you're right, just updated to 2.7 a the bug is not anymore present, thank you for the help and sorry for this useless post

PS: The download of the last version is impossible from my computer, server does not answer (I had to download it from my dedicated server first ... )

[DidierKlein 729]

As mentionned your model was probably not laying flat on the plate

[burtoogle 516]

Also, according to freecad, the model is buggy.