Jump to content
Ultimaker Community of 3D Printing Experts
0scar

Reset materials and print profiles in Cura 2.7

Recommended Posts

How to reset the print profiles / material profiles.

By deleting the Cura folder in ~\Appdata and reinstalling Cura, I do not get the profiles back I used to have in older Cura versions. The Ultimaker PLA filaments came with 3 profiles: fine, normal and draft, I now only see fine. What happened with the rest?

P.S.: I know that the material/print profile section in not performing up to par, but I just can't understand where all the default print profiles have gone to. I ran into a lot of problems when creating non-Ultimaker filament materials in Cura. E.g. the print profiles for custom materials are not "adhering" to the custom material you created. I already reported this.

Share this post


Link to post
Share on other sites

Switch the core or material of the second extruder. You probably have not-pva & bb-04 nozzle selected there.

Actually I had, but removing it, assigning an other core and material and switching back did the trick! Like I said, not performing up to par. But this fixes my problem, thank you for your help.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!