Jump to content
Ultimaker Community of 3D Printing Experts
S7evenAxis

Footprints and Dimensions on Ultiboard

Recommended Posts

Hey there guys,

 

I'm seeking some help for finding the proper dimensions and footprints when transferring from Multisim to Ultiboard, I'm having a really tough time finding the proper manufacturers to match the required footprints and dimensions that I need...

 

These are the measurements that I'm struggling with...

 

Resistors : Footprints:10.16mm Dimension : 6mm x 3mm

2.2 uF Capacitors : Footprints: 5.08mm Dimension : 7mm dia x 12mm height

10 uF Capacitors : Footprints: 7.62mm Dimension : 6mm dia x 3mm height

 

Those measurements will be evaluated if they're matching their requirement hence why I need to have them approximately.

 

I've got this circuit due for in a couple of days and I am completely stuck there so any help would be greatly appreciated!

Share this post


Link to post
Share on other sites

All the circuit boards are public domain. You can look at the exact measurements of the pads. My first question is which ultiboard is this exactly? The one for Ultimaker original? UM2? UMO plus? The ulticontroller on the UMO?

Not only are the schematics published, the exact circuit board layout is also which shows all conductors and all pads that these parts have to solder into.

some of the schematics are on github but give us more info first.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 130 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!