Btw, the settings which you feature in your list so far, was they provided to you by the makers by their own initiative, or it is you the ones who go first to them, asking if they wish to cooperate with you, with providing to you the data for their printers to be putted into your list?
They were provided by their own initiative. In some cases they were added by our developers in their own time (I've added a few machines for some people for instance).
Is this normal, or maybe it may be yet some clue for what its happening with my prints?
Thanks. Regards...
Ah, yeah. Some machines have a "variant" (so a pre-defined nozzle size). These can then be selected with a spiffy dropdown menu. The machine you are using doesn't have that, so it seems to have "undefined" for that bit. I doubt this is anything to worry about.
Recommended Posts
BiaC 0
Oh well: life's a matter of benefiting and being polite even with whom who may not need or deserve it, if there's a sincere motivation to do it... Otherwise, I guess that you hadn't got any motivation to add to your list the printers of other competitors, instead of leaving Cura just for Ultimaker machines.
Btw, the settings which you feature in your list so far, was they provided to you by the makers by their own initiative, or it is you the ones who go first to them, asking if they wish to cooperate with you, with providing to you the data for their printers to be putted into your list?
Though, if the problem isn't given by any missing settings for a specific variant version, then no discussions at all (as perhaps my machine may be intended as a variant of a Prusa i3 B: which isn't listed anyway, but I guess that it shouldn't be so different from a i3). Indeed, instead of returning back to what I said in the snip you selectively quoted, I think that the focus of the problem was "what causes the issue I was experimenting".
Anyway, let's drop this, 'cause it leads us nowhere: sterile quarrels has been enough. Rather, now I would take the occasion to ask you what does it means that, when saving a project, I get this (and I already setted as 0,4 the nozzle in the specs):
Is this normal, or maybe it may be yet some clue for what its happening with my prints?
Thanks. Regards...
Edited by Guest
Link to post
Share on other sites