Jump to content
iHaveEatenn

Advice regarding my bad print.

Recommended Posts

Posted · Advice regarding my bad print.

Hello,

I have encountered an issue with my Ultimaker 2+ 3D printer when it print. The photo below is what happen to my print when I use 0.4mm nozzle. Anyone have any idea what happened to the print? Much help needed! Thanks! :)

IMG_0554.thumb.JPG.314a5585d1c6e3e425ae704fad3b3138.JPG

IMG_0554.thumb.JPG.314a5585d1c6e3e425ae704fad3b3138.JPG

Share this post


Link to post
Share on other sites
Posted · Advice regarding my bad print.

Hi @Ihaveeatenn, welcome to the forums! It looks like your print bed might be a bit too low. Can you relevel it and tune it slightly higher? Also, is it PLA or another material?

Share this post


Link to post
Share on other sites
Posted · Advice regarding my bad print.

I agree with sander. Don't relevel - just turn the 3 screws 1/2 turn CCW to move the glass closer to the nozzle and try again.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!