Printing support for parts

[Crow 0]

Newbie here...

When printing with support PVA is a second build to the side normal?

Thanks!

[gr5 2,235]

That's called the wipe tower. You can disable that if you want. It can make for a slightly better quality print but usually you don't need it. Also I think it works better if you move it to the rear center - less likely to fall over in the center where the glass is usually higher/thicker.

[Crow 0]

That's called the wipe tower.  You can disable that if you want.  It can make for a slightly better quality print but usually you don't need it.  Also I think it works better if you move it to the rear center - less likely to fall over in the center where the glass is usually higher/thicker.

Thanks!