UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Der Wert "Speed" steht im Drucker bei Druckbeginn immer auf 100. Das sind allerdings keine 100 mm/s sondern 100%. Wenn Du über "Tune" auf 60 herunterregelst druckst Du nur noch mit 60% von 60 mm/s - also mit 36 mm/s!
I found that the firmware, depending on the G-Code flavour, is the default. I use reprap flavour which overrides this. I found myself stuck where the printer wasn't doing what I set in cura. turns out that ultimaker flavour is printer firmware defaults.
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
mikar 32
Hallo Bildstein,
Der Wert "Speed" steht im Drucker bei Druckbeginn immer auf 100. Das sind allerdings keine 100 mm/s sondern 100%. Wenn Du über "Tune" auf 60 herunterregelst druckst Du nur noch mit 60% von 60 mm/s - also mit 36 mm/s!
Viele Grüße
Link to post
Share on other sites
zerspaner_gerd 383
Hallo @Bildstein,
Oder @mikar er hat die Tinker Firmware, da steht die tatsächliche gedruckte Geschwindigkeit?
Wenn das der Fall ist dann musste du vielleicht ein paar Geschwindigkeiten in Cura mehr einblenden.
Gruß
Link to post
Share on other sites
rebekah_harper 60
Hiya,
I found that the firmware, depending on the G-Code flavour, is the default. I use reprap flavour which overrides this. I found myself stuck where the printer wasn't doing what I set in cura. turns out that ultimaker flavour is printer firmware defaults.
may or may not be the issue.
Bex
Link to post
Share on other sites