Ah that was the idea of the gallery thing but I hadn't finished the upload.
Here's some pics. I'm levelling with a piece of paper basically until the paper is just a teensy bit dragged by the head so I'll try a little lower I guess... Next Ultimaker upgrade - get some sort of touch sensitive heatbed that levels itself...
Recommended Posts
gr5 2,224
A picture would be helpful after the skirt is laid down. But what you are describing sounds like "bed levelling" issue. I don't mean levelling exactly but height. Try lowering (or possibly raising) the bed by a tiny amount. Make sure you level with a hot nozzle (as it expands when hot) and use a piece of paper to check in all 4 corners.
Also is packing density set to "1.00"? It should be.
Link to post
Share on other sites