UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
SandervG 1,521
Have you tried contacting Inted if they have the main board? Perhaps they have it available, but just not listed on their webshop.
Link to post
Share on other sites
gr5 2,224
Most resellers have MANY more parts than listed in their store.
Link to post
Share on other sites
printedman 1
I did the test again. Advice needed. Where is the fault? Build Plate? or Main Board? Thanks![Heating-Up-Nozzle.thumb.jpg.8370cd1e4ac09f87c8b7dc3ffd014954.jpg](//content.invisioncic.com/ultimake/monthly_2018_05/Heating-Up-Nozzle.thumb.jpg.8370cd1e4ac09f87c8b7dc3ffd014954.jpg)
Link to post
Share on other sites