UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Does the AppImage have a Toolbox menu? In 3.4, the plugin browser was renamed to Toolbox.
The curaplugin file should be compatible with Cura 3.3 (the PPA), but you are using it in the wrong way. Remove it from the local/share/cura/plugins folder, and instead drag and drop it in the Cuar window. It will then be extracted to the correct folder. Note that this will not work with Cura 3.4, because that requires a .curapackage file.
Finally, realise that freeCAD needs to be installed as well as the plugin.
2. At cura 3.4 I've got a "toolbox" menu. In the window it opens, I find a "menu" entry,but this is grayed out and will not open.
3. At cura 3.3.1, I tried the plugin installation as mentioned above. Cura says "installed properly" - I can now choose FC files but they are not installed. See error log (from terminal) attached.
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
ahoeben 1,955
Does the AppImage have a Toolbox menu? In 3.4, the plugin browser was renamed to Toolbox.
The curaplugin file should be compatible with Cura 3.3 (the PPA), but you are using it in the wrong way. Remove it from the local/share/cura/plugins folder, and instead drag and drop it in the Cuar window. It will then be extracted to the correct folder. Note that this will not work with Cura 3.4, because that requires a .curapackage file.
Finally, realise that freeCAD needs to be installed as well as the plugin.
Link to post
Share on other sites
herrdeh 0
Thank you for your time.
1. FC is installed (0.18)
2. At cura 3.4 I've got a "toolbox" menu. In the window it opens, I find a "menu" entry,but this is grayed out and will not open.
3. At cura 3.3.1, I tried the plugin installation as mentioned above. Cura says "installed properly" - I can now choose FC files but they are not installed. See error log (from terminal) attached.
HTH, Cheers,
Wolf
Fehler-cura.log
Link to post
Share on other sites