It's not a Ultimaker, it's a Monoprice Maker Select v2, but it uses Cura. So this is definitely a physical flaw, not an effect of the settings? What is the function of the TFN/TFT?
tinkergnome 927
10 hours ago, Calmc545 said:So this is definitely a physical flaw, not an effect of the settings?
Hard to guess... which printer profile do you use? Have you checked the material diameter setting?
Prusa Mendel I3, nozzle size 0.4 mm, material diameter size 1.75mm. Everything seems to match with the Monoprice specs. Could a clog be the issue?
Recommended Posts
gr5 2,224
This is definitely underextrusion.
What printer is this? If this is a UM2 series then immediately buy a TFN/TFT and replace it (that white teflon part).
There are about 20 causes for underextrusion but I'm not going to list them without knowing the printer model.
Also do some cold pulls (right in the menu for the UM3).
Link to post
Share on other sites