[solved] cannot set z value > 0

[herrdeh 0]

Hello,

I tried to set positive z values to create overlapping reinforcement sections in the middle of my item. I can type a number >0 into the z value box, but it will always reset to 0 after ENTER. Is there a control to enable z>0?

 

Cheers,

Wolf

Edited September 5, 2018 by herrdeh

[peggyb 171]

in the preferences you can disable 'automatically drop model on the buildplate'

[herrdeh 0]

Oh. It's in the "General" section at first page - and this is not covered by the search function for settings. Therefore, I could not find it. But I was certain, it must be existant...

In German: "Setzt Modelle automatisch auf der Druckplatte ab"

 

Thank you!

W