UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
zerspaner_gerd 383
Hallo,
Ich meine das ich das schon mal gesehen habe!
Das Problem ist das die STL oben und unten nicht richtig geschnitten wurden das heißt oben und unten sind die Modelle (die Wände) offen.
Du kannst mal die Röntgen Ansicht prüfen, es darf nichts rotes markiert sein.
Cura schaft es nur bei einen Teil zu reparieren und wenn zwei teile geladen wurden schaft das Cura nicht mehr automatisch.
Ich finde das alten Post jetzt nicht somit weis ich nicht ob da eine Lösung gefunden wurde.
Du kannst dir aber mal die Netzreparaturen (sind in der Seitenleiste ausgeblendet) anschauen und mal durch probieren ob da eine Einstellung hilft
Gruß
Link to post
Share on other sites