Printer fill in flat surface incorrectly.

[Kars007 0]

Dear people,

 

I am printing abs on my cr-10 on 245 degrees with printing speed of 40 mm/s. The printer doesn’t fill in flat surface in corners of some layers. The walls are printed correctly however. What is wrong with my printer or settings of cura.

 

Thank you in advance!!

Best regards,

 

Kars

[gr5 2,230]

 If that's the bottom layer then the problem is your nozzle is too far from the bed.  You need to squish the bottom layer more.

[Kars007 0]

2 hours ago, gr5 said:

 If that's the bottom layer then the problem is your nozzle is too far from the bed.  You need to squish the bottom layer more.

Thank you for your fast respons. This is the upper layer of the print. 

 

Best regards Kars