yellowshark 153
Lol and if none of that works for you try reducing the flow for 1st layer down to 70%. Personally I take two layers to get back to 100% but switching straight to 100% for layer 2 may be OK
Lol and if none of that works for you try reducing the flow for 1st layer down to 70%. Personally I take two layers to get back to 100% but switching straight to 100% for layer 2 may be OK
Recommended Posts
gr5 2,224
What I see in your photos I've seen before. It can be caused because the head is too far from the glass (the glass can be tilted such that one corner is higher) or it could be oil on the glass or a combination of head too far plus other factors.
You shouldn't have any problems at all with this kind of thing. Here is a video that explains how to make your filament stick like hell to the glass. It's a long video but it is packed full of valuable information, insight and *why* you have to do what I recommend:
Link to post
Share on other sites