The mystical retraction and traveling

[heinzel 0]

Hi togehther,

 

1. Unwanted lines:
=> I wonder how I can make Cura 3.6.0 not always print unwanted lines in the print object on the first layer.
Of course I activated Retraction and Z Hop - but somehow the Cura does not seem to care.
Below is an example.
 

These arrows marked with the red are wrong. That's a pure travel. But with full filament.
In the finished print it looks like the second picture.
Attached also pics, how my settings look like.


2. Why is Cura only traveling across printed areas?

It seems like this is only 3.6.0 - but I'm not sure.

E. g. to travel from top right to bottom right, Cura drives extra over the middle left. Exactly over allready printed areas. This is unnecessary and not desirable.

=> How can I turn this off?

Also Z Hop did not work. I am pretty sure, that this behavior was earlier not.

 

Regards,

Hein

 

[burtoogle 514]

Set combing mode to "no skin".

[Brilliant_Name 1]

Under travel, use Max comb distance without retract to some value higher than 0.

After that I didn't need z-hop.

[heinzel 0]

Many thanks. I will check the behavior with both Settings.

 

[shakeNbake444 0]

did this work? I have the same issue. it's super annoying. Although i have 4.1 and zhop creates a corrupt command in the gcode so i cant use it until they fix it. This is the only thing different with my settings. 

[johnse 31]

On 7/5/2019 at 7:07 PM, shakeNbake444 said:

Although i have 4.1 and zhop creates a corrupt command in the gcode so i cant use it until they fix it.

 

See this thread, it has a workaround for that bug: 

 

[shakeNbake444 0]

7 hours ago, johnse said:

 

See this thread, it has a workaround for that bug: 

 

Thank you! works again!