Jump to content

Submerging PLA when printing with PVA


nicklas

Recommended Posts

Posted · Submerging PLA when printing with PVA

Hi,

 

I just did my first print with PLA and PVA support. It's a big print and it took about 30 hours to finish. Now I want to remove the PVA support. 

 

Is it critical to submerge the entire PLA into water or can I simply only submerge the parts with PVA?

 

I know that PLA can be affected by water hotter than 35 degrees Celcius, and I want to be as gentle with my print as possible so I won't damage it.

 

Do you have any tips and tricks? 

 

Thanks :-)

  • Link to post
    Share on other sites

    Posted · Submerging PLA when printing with PVA

    Hi @nicklas

    if there are parts of your print that don't have any PVA on it, you don't necessarily need to submerge it in water. The water is solely used to dissolve the PVA. If you have a method that prevents your print from tumbling over, or sink, and only keeps the PVA under, go for it. 

     

    With most prints, I think that won't be the case though. But you don't necessarily need to keep it at 35ºC, I think our pages say don't go higher. But you can go a bit lower 🙂

     

    Hope this helps!

  • Link to post
    Share on other sites

    Posted · Submerging PLA when printing with PVA

    I normally just have a big bucket of water to dissolve the PVA. the water only gets replaced when to milky, so it's more or less always room tempter around 17-20ºC. so in my experience PVA will dissolve fin in way lower tempters. I speed up the proses by brushing of the PVA when it gets mucous. if it takes to long or are hard to remove I would say its probably more because the water is saturated, then because of the tempter. So if you are afraid to damage the PLA just let it sid longer in colder water and you should be fin. 

     

    In general its only the parts with PVA that needed to be in water. But depending on the model and how the PVA support is, there can be some stringing caught between the PLA layers. 

     

  • Link to post
    Share on other sites

    Posted · Submerging PLA when printing with PVA

    Thank you, NBull, that was really helpful. I think I did experience some stringing issues because I discovered some holes in the PLA where the support has been, and it's the first time I've ever seen that issue. 

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...