On 1/26/2019 at 9:52 PM, RudydG said:Personaly, i get the best results with dymafix.
+1 for Dimafix, it is really helpful.
-
Our picks
-
.png.790188cb2d32e3558395d7e5fbc992f3.png)
UltiMaker Cura 5.9 stable released!
ArunC posted a topic in UltiMaker Cura,
Here comes Cura 5.9 and in this stable release we have lots of material and printer profiles for UltiMaker printers, including the newly released Sketch Sprint. Additionally, scarf seams have been introduced alongside even more print settings and improvements. Check out the rest of this article to find out the details on all of that and more-
-
- 5 replies
Picked By
MariMakes, -
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 4 replies
Picked By
MariMakes, -
-
.png.790188cb2d32e3558395d7e5fbc992f3.png)
Recommended Posts
SandervG 1,521
Hi, have you visited this page already? It may contain all the tips you're looking for!
Link to post
Share on other sites
RudydG 62
Personaly, i get the best results with dymafix. Also on um5.
Just don’t use support that requires cooling, you will get into trouble. No fans!
Link to post
Share on other sites
Kevinrhug 0
Thanks guys. I did see the adhesion sheets but could not remember where. I have a part that I want to print from nylon and PC and then test to see which one is better for the application.
Link to post
Share on other sites