2 hours ago, gr5 said:I recommend you just mess with flow if you only have one or two spools like this but here you go:
Make sure you are in PREPARE mode (at the top of the screen). Click on your printer on the left, select "manage printers..." select "machine settings", click on "Extruder 1" tab. Change it there.
I think potentially you could have 2 printers shown in cura with 2 different filament diameters.
You might additionally have to create materials with the same filament diameter - not sure - I think not - I think you only change it in printer settings.
I've never done this myself.
Thanks for the response!
I actually tried this, but changing any diameter settings at all has absolutely no effect whatsoever. even when changing it by 0.3mms, no difference can be seen in the software, or finished print.
Flow, however, worked to fix my problems with only a small adjustment.
Recommended Posts
gr5 2,224
I recommend you just mess with flow if you only have one or two spools like this but here you go:
Make sure you are in PREPARE mode (at the top of the screen). Click on your printer on the left, select "manage printers..." select "machine settings", click on "Extruder 1" tab. Change it there.
I think potentially you could have 2 printers shown in cura with 2 different filament diameters.
You might additionally have to create materials with the same filament diameter - not sure - I think not - I think you only change it in printer settings.
I've never done this myself.
Link to post
Share on other sites