UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Over Extruding with an AnyCubic Mega S and Cura 4.4
Posted
· Over Extruding with an AnyCubic Mega S and Cura 4.4
Hi and welcome!
You can try if it is better when you turn off combing (search for the setting in Cura)
For me it seems it is a normal travel move inside the object and therefore no retract happens, because it doesn't matter. With combing off, the printer should retract also when traveling inside the object.
I am not sure if there are more settings with an effect on the retract, I normally don't care about it.
To avoid just the line on your first picture you can set combing to not in skin, that you don't have such lines on the top surface for example.
Posted
(edited)
· Over Extruding with an AnyCubic Mega S and Cura 4.4
Thank you very much... This has fixed my issue.
I am very grateful for your help and so will my grandson whose xmas present I am trying to print. I know I am cutting it fine to be ready for the day, but the printer was an early present for me 🙂
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
Smithy 1,145
Hi and welcome!
You can try if it is better when you turn off combing (search for the setting in Cura)
For me it seems it is a normal travel move inside the object and therefore no retract happens, because it doesn't matter. With combing off, the printer should retract also when traveling inside the object.
I am not sure if there are more settings with an effect on the retract, I normally don't care about it.
To avoid just the line on your first picture you can set combing to not in skin, that you don't have such lines on the top surface for example.
Link to post
Share on other sites
gr5 2,224
set combing to be "everywhere but skin". something like that.
Also in layer view, turn on movements (check the box). You can see which moves are retraction versus non-retracting (different shades of blue).
You want to make sure these moves are retracting moves (by default they are non-retracting and leave that line you don't like).
Link to post
Share on other sites
haroldjclements 0
Thank you very much... This has fixed my issue.
I am very grateful for your help and so will my grandson whose xmas present I am trying to print. I know I am cutting it fine to be ready for the day, but the printer was an early present for me 🙂
Kind Regards,
Harold...
Edited by haroldjclementsLink to post
Share on other sites