Random paths in top layer

[Rotor_Blade_Guy 0]

Hello,

 

I am getting path lines in the finish layer which I would like to avoid. Majority of the layer is built using symmetrical pattern but there are movements that end up cutting across and leaving lines that now I have to figure out how to 'blend out'. Is there a setting in the Cura that would enforce behavior that would eliminate this from happening?  

 

I am using Ultimaker S5, Cura 4.4.1 and Ultimaker Tough PLA filament

 

Thank you for your help. 

[Smithy 1,144]

Try to set "combing" to "not in skin" then it should be better.