request- give us back aluminium build plate in firmware

[JASON128 6]

please Ultimaker firmware guys,  please give us this back!

 

The nice thing about it is it stored its own offset data for each build plate...

This means when using a 3rd party build plate- be it a spring steel, Gardoplate, PEI  or whatever, it kept the data,  and one could swap back to glass without any need to manually calibrate again.  I have been using an spring steel PEI sheet from aliexpress  for 2 months, and love it compared to glass.-  why you guys don't offer something similar I don't understand.

 

The fact that the firmware  functionality was already there, and then it was removed, was just rubbing salt in the wound, after having to buy a 3rd party build-plate to begin with!   I know Ultimaker are no longer planning a alternative build plate,  but there ARE other options around, and at least give your customers the option to use them easily.  you owe them that much surely- especially when you have already done the work.

 

 

 

 

 

 

[Szahari 30]

Hi  Jason,

 

Thanks for your feedback! I think we learn something new all the time about usage into the printers. I think it wouldn't be an impossible task to restore the functionality. The use case you've mentioned is outside something that we would normally consider however, but its always great to see how people are using these printers.

 

I'll go ahead and poke around and see what can be done in terms of restoring this functionality. As always, the more demand the better it is to get priority on something, so if more likely it is to get picked up sooner rather than later!

[Jasonjason 6]

Thanks for responding.

it would probable be the same currently when going from bare glass to adhesion sheets? One would need to re calibrate with the paper card again?
being able to store the different bed type would save having to recalibrate each time.  So it would be support ultimaker beds, not just 3rd part bed surfaces 

[tabiznet 3]

Ah so that explains why its gone. Why would you remove it in the first place? +1 for putting it back

[robinmdh 100]

Another explanation is that it changes more. It did also change the PID settings for heating the buildplate (5 to 10 degrees constantly off target depending on whether it's heating or constant) which won't help you if you don't know about it but yeah it would solve some issues. But just bringing it back as is sounds not great either IMHO.