1 hour ago, SandervG said:Hi, could you share your Cura project too, so we can look at your full set of settings? Thanks!
Sure. I didn't have a .3mf file saved for this print, but I recreated it as best I could recall. We needed an extreme level of structural integrity in this component, so the wall count is abnormally high with 75% infill to bolster any compression loads the walls couldn't handle. Because I've had issues with oozing, I turned on coasting and increased retraction to 8mm. Otherwise it should be a stock 0.4mm Sprint profile.
Edited by TrueNorth
Recommended Posts
SandervG 1,521
Hi, could you share your Cura project too, so we can look at your full set of settings? Thanks!
Link to post
Share on other sites