UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Contact your reseller. There is a procedure for restoring the firmware, but since it requires to remove the bottom cover there is a danger for touching high voltage components. Your reseller can help you and use the correct procedure to meet your countries regulations.
Mine did the same thing and because it is out of warranty all I get from Ultimaker is "sorry about your luck"! Mine will not recover with the SD card. Ultimaker's position is no way the firmware did it.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
CarloK 204
Contact your reseller. There is a procedure for restoring the firmware, but since it requires to remove the bottom cover there is a danger for touching high voltage components. Your reseller can help you and use the correct procedure to meet your countries regulations.
Link to post
Share on other sites
Reddy2Print 3
Mine did the same thing and because it is out of warranty all I get from Ultimaker is "sorry about your luck"! Mine will not recover with the SD card. Ultimaker's position is no way the firmware did it.
Facts:
Worked fine pre-firmware update
Froze during firmware update
Only gives screen above when powered on
Will not boot from SD card
Link to post
Share on other sites
Navin2020 5
that is terrible?.. for such a costly item (shocked)
Link to post
Share on other sites